In-Process Grinding Gauge

Electronic In-Process Grinding Gauge - Table Mounted Type (TMG-01)

This Inprocess gauge is suitable for grinding of uninterrupted external diameters. It measures the part during grinding and gives the machine the necessary information for grinding cycle. The measured values are transmitted to the controller for coarse, fine, sparkout and wheel retraction. The result is higher precision, productivity and reliablity of the process. Inprocess gauge composition consist of a measuring head, an electronic amplifier-controller with microprocessor for CNC machines. it is possible to install this gauge on all cylindrical grinding machines.

• Item Code: TMG-01

Electronic Inprocess Grinding Gauge - Swing arm Type:

This measuring gauge head can be used for automatic inprocess size control of parts with uninterrupted surfaces and also interrupted surfaces with special calipers. after the work piece is loaded on the machine and the operation cycle is started the wheel head advances towards the work piece. The measuring head and caliper assembly is loaded on the component for measurement and control. The measured values are transmitted tothe controller for coarse, fine, sparkout and wheel retraction.

• Item Code: SA1P-01

Inprocess Swing Arm Grinding Gauge for Spline Diameter:

The special Spline diameter gauging caliper ensures smooth and accurate gauging of spline diameter. Smoothing agents may be required depending on parts. The Spline Caliper is special for specific diameters. After the work piece isloaded on the machine and the operation cycle is started the wheel head advances towards the work piece. The measuring head and caliper assembly is loaded on the component manually for measurement and control. The measured values are transmitted tothe controller for coarse, fine, sparkout and wheel retraction.

Measuring Range Specific to Diameters MODEL : SPL-SA1P-01

Table Mounted Two Probe Inprocess Gauge for Internal Diameter:

This can be independently used as internal uninterrupted diameter gauging. This gives closed loop signal to the machine and to the wheel head. The result is higher precision, productivity, reliability and close accuracy of the process. Inprocess Gauge composition consist of a measuring head, reciprocating hydraulic cylinder for grinding machines. It is possible to install this gauge on all Cylindrical ID Grinding Machines.

Mechanical In-Process Gauge - Swing Arm Type:

Tespa Mechanical Grinding Gauge with tublar construction provide accurate method of indicating the dimensions during grinding of cylindrical components.

Dial type indicators can be used with adequate resolution. The measuring head is engaged by the operator on the component for gauging.